Friday, February 28, 2014

Troybilt mower 65 briggs starts but wont stay running

Troy-Bilt mower, 6.5 Briggs, starts, but won't stay running ???


I have a 3 year old T-B Tru Cut 100, it starts when primed or sprayed but won't stay running on its own. The first outing this spring my wife put some bad gas in it and it obviuosly wouldn't start, I drained the tank, made sure the line was clean, pulled the carb off, cleaned the float bowl, made sure the needle and seat were clean and unblocked, changed the oil, air cleaner and plug. It started right up and has been running good all season til now!!!! My son , a responsible 32 year old, borrowed it, because his was down with a broken cable, said it stalled once while he was mowing, seemed hard to start he said, but he was able to finish his grass, small area BTW, approx. 30 x 40 ft. I got it to my house it took a couple of pulls to get started and seemed to want to shut off. I started to cut went about 50' and it died, took about 8-9 pulls to get it restarted, let it run free over the sidewalk for a minute or so, proceeded to cut again and the same thing happened. Now it only runs when primed or sprayed, will stay running if you keep priming, but dies when you stop. Drained the tank, cleaned the line, etc. as before. Had it apart 5 times since yesterday, same thing, will only run when primed,etc. Any ideas that I may have missed??? Thanks Don Did you notice the little holes in the nut that held on the bowl, make sure they are clean. Sounds like your main jet is stopped up. Have a nice day. Geo Originally Posted by geogrubb Did you notice the little holes in the nut that held on the bowl, make sure they are clean. Sounds like your main jet is stopped up. Have a nice day. Geo Thanks for the reply I blew thru it the old fashion way and then with compressed air, did the bowl vents too, etc.Tried running with the gas tank cap loose and off, even, still no luck. The carb to manifold uses an o-ring instead of a gasket setup, It's the original thought maybe its past its usefulness and is sucking air, kind of doubt it though. OK how about this, get something to catch the fuel and remove the fuel line from the carb, did we get a nice fuel flow, reattach the fuel line, remove the bowl to see if fuel is flowing into the bowl, did you get a nice fuel flow, if all the above is true the carb main jet is still stopped up. I had a Tec TVXL840 that had a small piece of grass in the main jet when I used carb cleaner spray to clean the jet it only moved out of sight and would work its way back to clogging in a little while it about drove me nuts. Have a nice day. Geo Yes. Drained the tank, fresh gas, good flow. Hole in bowl nut is clear. I even put the float and needle in without the bowl on and checked if the float and needle was shutting off the gas flow and it worked properly. Soak in a bath cleaner (I like Napa # 6402) and recondition with the proper OE carburetor kit and any necessary mounting gasket(s), if needed. puey; I just bought a gallon of 6402 from my local NAPA dealer it was $42.00, unreal. When I use it up I think I will try the Gunk brand I think it is about $12.00, Berryman just stinks too bad. Have a nice day. Geo








Related Posts:




  • Ryobi trimmer 725r 31cc 17 wont stay running

    Ryobi trimmer 725R 31CC 17 won't stay runningThis trimmer will start fine in choke or half-choke and will stay running only in half-choke. It will not start in RUN or if I start it in half-choke a...


  • Troybilt tb525cs 4cycle trimmer wont start

    Troy-Bilt TB525CS 4-Cycle Trimmer Won't StartHave had this for about four years, really haven't had any problems with it besides an oil leak from time to time over the years. Never found the sourc...


  • Tecumseh 6hp tiller engine wont start

    Tecumseh 6hp Tiller engine won't startSo I asked my father-in-law to borrow his yard machine tiller. He said if I can fix it, it's mine. The last time it was used was over a year ago and the gas h...


  • Whirlpool water heater pilot wont stay lit

    whirlpool water heater- pilot won't stay litWe replaced the thermocouple first b/c it wouldn't light at all but the ignitor was working and gas was working. We were able to then get a flame, but i...


  • Toro 22 recycler lawn mower problem

    Toro 22 Recycler Lawn Mower ProblemI have a Toro mdl 30008 about 8 yrs old push mower, not self propelled. After using mower in back yard without any problem, I went to frt yard, refueled, and mow...